|
1) Loosen the black hose clamp with a phillips screwdriver
|
|
2) Loosen the two screws at bottom with a 8mm socket wrench.
|
|
3) Disconnect the hoses at one intake at right side and two of the intakes at left side. Keep the manifolds in order so you know which go back where.
|
|
4) You can just grab the tube and pull and it'll come right out with little
effort. Remember to cover the heads and careful not to leave dust in there.
|
|
5) The manifolds are cast aluminum with very rough surface.
|
|
6) Step 1, I used a Dremel with small 200 grit sanding drums.
|
|
7) Step 2, I used a poolish disk (about the same result as using a 1000 grit sanding drum)
|
|
The finished result:
|
|
If you remembered to keep the manifolds in order so you know which go back where, you are now ready to assamble it. |
Quick Links